Connecting Devices - Fujitsu Stylistic User Manual

CONNECTING DEVICES

Once your system is installed in the Tablet
Dock, you are ready to attach external devices
to the dock.
To Attach an External VGA Monitor
This option allows you to use an external
monitor with your system. The only
requirement is that the external device
(monitor, projector) is a VGA device. Consult
the instructions that come with the device.
1. Securely insert the external monitor plug
into the display port on the back of the
Tablet Dock (Figure 2) . Always check the
icon by the port before inserting. Tighten
screws if available.
2. You may switch between the internal
monitor and external monitor using the
Display Configuration utility located in the
system tray at the bottom right of the
screen, or through the Control Panel
settings.
To Attach a USB device
Use of the USB ports allows attaching USB
devices to a docked system.
1. Securely insert the connector into one of
the three USB ports on the left side of the
Tablet Dock (Figure 2) . It may be necessary
to wait a short time while the appropriate
drivers are located and installed by the
system.
To Attach an IEEE 1394 device
The IEEE 1394 jack allows attaching peripherals
such as digital cameras to a docked system.
1. Securely insert the connector into the IEEE
1394 jack on the left side of the Tablet Dock
(Figure 2) .
Refer to the device manufacturer's installation
and usage instructions for configuration
instructions.
Ta bl e t D o ck U s e r 's G u i d e
To Attach External Audio Equipment
The Tablet Dock provides a Line Out jack for
headphones or external speakers.
Connecting external speakers (including
headphones) or microphone disables the
system's internal speaker or inter nal
microphone.
1. To attach an external audio device, insert
the plug into the Line Out jack on the back
of the Tablet Dock (Figure 2) .
To Attach a LAN Device
The LAN (RJ-45) jack allows you to connect
the system's internal Fast Ethernet to a LAN,
or broadband devices such as a cable modem,
DSL, or satellite internet.
1. To attach a LAN device, insert the plug into
the LAN (RJ-45) jack on the back of the
Tablet Dock.
Refer to the device manufacturer's installation
and usage instructions for configuration
instructions.
USING THE INTERNAL MEDIA
DRIVE
The Tablet Dock is outfitted with either a CD-ROM
drive or a Combo DVD/CD-RW drive,
depending upon the configuration of your dock.
A CD-ROM drive allows you to access
software, data, or audio CDs. A DVD/CD-RW
combo drive allows you to access movies,
audio, software, data, or audio DVD/CDs, and
to write data onto recordable CDs.
7