Table of Contents
Advertisement
www.aeg.com
8
DAILY USE
WARNING!
Refer to "Safety information"
chapter.
IGNITION OF THE BURNER
WARNING!
Be very careful when you use
open fire in kitchen environment.
Manufacturer decline any respon-
sibility in case misuse of the flame
Always light the burner before you
put cookware.
To light the burner:
1.
Turn the control knob counterclock-
wise to the maximum position (
) and push it down.
2.
Keep the control knob pushed for ap-
proximately 5 seconds; this will let
thermocouple to warm up. If not, the
gas supply will be interrupted.
3.
Adjust the flame after it is regular.
If after some tries the burner does
not light, check if the crown and
its cap are in correct positions.
Each control knob has a pilot
light. It lights up when you turn
the control knob.
A)
Burner cap and crown
B)
Thermocouple
C)
Ignition candle
A)
Burner cap
B)
Burner crown
C)
Ignition candle
D)
Thermocouple
WARNING!
Do not keep the control knob
pushed for more than 15 seconds.
If the burner does not light after
15 seconds, release the control
knob, turn it into off position and
try to light the burner again after
minimum 1 minute.
In the absence of electricity you
can ignite the burner without elec-
trical device; in this case approach
the burner with a flame, push the
relevant knob down and turn it
A
counter-clockwise to maximum
gas release position.
If the burner accidentally goes
out, turn the control knob to the
off position and try to light the
burner again after minimum 1 mi-
B
nute.
The spark generator can start au-
tomatically when you switch on
C
the mains, after installation or a
power cut. It is normal.
TURNING THE BURNER OFF
To put the flame out, turn the knob to the
symbol
.
A
B
C
D
Advertisement
Table of Contents
