General Maintenance; Lubrication; Replacing The Guide Bar And Chain - jcb -CS38 Safety And Operating Manual Original Instructions

MAINTENANCE
WARNING
When servicing, use only identical replacement parts. Use of any other parts may
create a hazard or cause product damage.
WARNING
Always wear safety goggles or safety glasses with side shields during power tool
operation or when blowing dust. If operation is dusty, also wear a dust mask.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to
damage from various types of commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, lubricant, grease, etc.
WARNING
Do not at any time let brake fluids, petrol, petroleum-based products, penetrating
lubricants, etc., come in contact with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal injury.

LUBRICATION

All of the bearings in this product are lubricated with a sufficient amount of high grade
lubricant for the life of the unit under normal operating conditions. Therefore, no further
lubrication is required.

REPLACING THE GUIDE BAR AND CHAIN

See Figures 36-45.
DANGER
Never start the engine before installing the guide bar, chain, clutch cover and clutch
drum. Without all these parts in place, the clutch can fly off or explode, exposing the
user to possible serious injury.
WARNING
To avoid serious personal injury, read and understand all the safety instructions in this
section.
 Always place the switch in the "Stop" (0) position before you work on the saw.
 Make sure the chain brake is not set by pulling the chain brake lever/hand guard
towards the front handle to the "Run" position.
SL7 1TB
Customer Helpline 0845 600 5526 Monday to Friday 09.00 to 17.00
www.JCBdiy.com
JCB-CS38_960488008-01_Manual_final_ OEM licence.indd 26 JCB-CS38_960488008-01_Manual_final_ OEM licence.indd 26 12/3/2010 5:58:31 PM 12/3/2010 5:58:31 PM