Raymarine 37STV User Manual page 64

60
pairs. you will have to carry out a manual soft key press
during this section of the set up procedure. The test will check
for DTV101 and you will get an OK. It will then check for
DTV119, and you will again get an OK. As it begins searching
for DTV110# you will have to manually press the SAT B pair
on the ACU. The receiver will then be able to locate
DTV110#.
4. Once set up is complete, the receiver will start downloading
the guide. As this occurs the receiver will tell the ACU when to
switch satellites. Since the receiver can only switch between
the main satellite and the DiSEqC satellite - SAT A and SAT
A* or SAT B and SAT B* - the guide will be likely to only
download channels from two of the three satellites at this
time. The channels from the third satellite will populate the
guide over a period of time. This period of time can be as little
as 20 minutes or extend to several hours. You will not be able
to watch all of the channels until the guide is fully populated.
Raymarine 37STV Satellite TV System