Download
Share
Print this page
  1. Manuals
  2. Brands
  3. HERO Manuals
  4. Pressure Washer
  5. PW-2530-AC
  6. Safety and operating manual

HERO PW-2530-AC Safety And Operating Manual

Commercial grade cold water pressure washer
Hide thumbs

Advertisement

Quick Links

Download this manual
SAFETY AND OPERATING MANUAL
AND UNDERSTANDING ALL SAFETY AND OPERATING INSTRUCTIONS
FACTORY LOCATED AT:
720 EATON WAY
DELTA, B.C. CANADA
V3M 6J9
PHONE: (604) 522-6543
Owners Manual
PW-2530-AC
COMMERCIAL GRADE
COLD WATER PRESSURE WASHER
WARNING: DO NOT OPERATE THIS EQUIPMENT WITHOUT READING
FAX: (604) 522-8735
2500 PSI @ 3 GPM
Version 5 Feb 2006
SEE PAGES 3 – 14
www.hero.ca
TOLL FREE: (800) 494-4376
Page 1
U.S.A ADDRESS:
P.O. BOX 75
CUSTER, WASHINGTON
98240-0075
PW2530-AC

Advertisement

loading
Need help?

Need help?

Do you have a question about the PW-2530-AC and is the answer not in the manual?

Questions and answers

Related Manuals for HERO PW-2530-AC

Summary of Contents for HERO PW-2530-AC

  • Page 1 PW-2530-AC COMMERCIAL GRADE COLD WATER PRESSURE WASHER 2500 PSI @ 3 GPM Version 5 Feb 2006 SAFETY AND OPERATING MANUAL WARNING: DO NOT OPERATE THIS EQUIPMENT WITHOUT READING AND UNDERSTANDING ALL SAFETY AND OPERATING INSTRUCTIONS SEE PAGES 3 – 14 FACTORY LOCATED AT: U.S.A ADDRESS:...
  • Page 2 Table of Contents Safety Instructions Important Operating / Maintenance Instructions Start-Up & Operation Nozzle Selection & Chemical Injection Trouble Shooting Pump Schematic & Parts List Unloader Valve/Chemical Injector Schematic & Parts List Pressure Washer Cart Exploded View Warranty Owners Manual Page 2 PW2530-AC...

  • Page 3: Safety Instructions

    Change oil in pump after the first 50 hours, then every 500 hours. Use 30W Non-Detergent Hydraulic oil. Available from Hero Industries, Part # PW-5015 Change engine oil as specified by the Honda. See Honda owners manual. Do Not run washer longer than 3 minutes with gun closed, as this can result in damage to the seals.
  • Page 4 START-UP AND OPERATION INTRODUCTION Dipstick (Yellow) 1.Verify that the vented YELLOW dip stick is installed in the pressure washer pump. Remove the RED shipping plug (if present) from top of the pump and replace it with the YELLOW oil level dipstick provided. Fig. 1 Pump oil should be visible half way up sight glass.
  • Page 5 START-UP AND OPERATION INTRODUCTION 11. Select the desired tip for the job. Insert tip into wand (quick- connect fittings). 0º Direct Spray, Direct or Concentrated Cleaning. YELLOW 15º Narrow Fan, General Use. Select & Insert Nozzle GREEN 25º Medium Fan, General use. WHITE 40º...

  • Page 6: Pump Schematic & Parts List

    PUMP SCHEMATIC & PARTS LIST REPAIR KITS Kit # Ref # Included 6, 7, 8, 10, 11, 12,(17) 15, 16 20, 21, 22 18, 19, 20, 21, 22 18, 19, 21, 22 Number of Pieces Ref # Part # Description Kit # Ref # Part #...
  • Page 7 UNLOADER VALVE AND CHEMICAL INJECTOR Ref # Part # Description UNLOADER SERVICE The unloader is made up of may small o-rings, PW-1130 Unloader Assembly springs and check balls. Repair kits are PW-1060 Filter Washer available to replace these “Soft Goods”. Repairs PW-1060 Filter Washer, Pack of 2 requiring the replacement of valve bodies or...
  • Page 8 PRESSURE WASHER CART SCHEMATICS REF # PART NUMBER DESCRIPTION QTY REQ’D PW4330-1781 BASE PW4330-1441 HANDLE, LONG PW4330-1434 HANDLE, SHORT PW4330-1436 FOOT BRACKET PW4330-1726 WHEEL, TIRE 10.5” PNUEMATIC PW4330-1727 AXLE PW4330-1435 GROMMET PW4330-1211 CARRIAGE BOLT, 3/8-16 X 1” PW4330-1114 FOOT PAD, 2.5” DIA PW4330-1115 FLAT WASHER, 3/8”...

  • Page 9: Warranty

    WARRANTY I.C.T.C. H.E.R.O. Products Group pressure washer is warranted to be free from defects in materials and workmanship under normal use for a period of two years from the original date of purchase, when operated and maintained in accordance with the Maintenance and Operation Instructions supplied with the unit.

  • Page 10: Trouble Shooting

    TROUBLE SHOOTING Problem Possible Cause Solution Pump running normally Pump is sucking in air. Check that all hoses and fittings are tight. but pressure washer Valves worn or dirty. Check valves, clean or replace. does not achieve rated pressure Insufficient water flow. Increase water supply.
  • Page 11 ACCESSORIES Ref # Part # Description Ref # Part # Description PW-1430 Gun & Wand Assembly, 3000 psi Max. PW-1047 Nipple, Steel, Female, 1/4” NPT PW-1181 O-Ring, 1/4” Coupler PW-1057 Nipple, Steel, Female, 3/8” NPT PW-1181-6 O-Ring, 1/4” Coupler, Pack of 6 PW-1046 Nipple, Steel, Male, 1/4”...