Connecting To An External Memory Device - BenQ GP20 User Manual

Connecting to an external memory device

Connecting an SD card
To connect the projector to an SD card:
Connect an SD card to the SD card slot on the projector.
• The maximum memory capacity supported for an SD(HC) card is 32 GB. (The maximum
capacity supported for external memory is based on our factory test. Your experience may
differ depending on the manufacturer of the memory device.)
• The projector may not be compatible with some SD cards.
Connecting a USB storage device
To connect the projector to a USB storage device:
Plug the USB storage device into the Type A USB socket.
• This product supports USB memory device and HDD (Hard Disk Drive). Only the partition
that was most recently used will be mounted. (The maximum capacity supported for
external memory is based on our factory test. Your experience may differ depending on the
manufacturer of the memory device.)
• The Type A USB port provides up to 500 mA of power for HDDs when connected to this
projector. In the event that large capacity HDDs cannot be read by this projector, it may be
due to insufficient power. In this case, connect the HDD to an external power source with a
Y-type USB cable to provide HDD with extra power.
• This product does not support multi-card readers.
• This product does not work if the USB storage device is connected by a USB HUB.
• Products that do not comply with standard USB specifications might not operate normally.
(USB flash drive)
25
Connection