Connecting To A Network - Toshiba dynadock U3.0 User Manual

Setting Up the dynadock™ and Connecting Peripherals
NOTE
Connecting to the HDMI
To connect a display to the HDMI
1 Plug one end of the HDMI
port on the HDMI
2 Plug the other end of the HDMI
out port on the dynadock™.
NOTE
NOTE
NOTE
You can customize the video settings of the dynadock™. See
video settings" on page 25

Connecting to a network

Connect one end of a network cable (not provided) to the Network port
(RJ-45) on the dynadock™ and the other end to your network.
If the network is not automatically connected, configure the network
properties of the Ethernet adaptor as follows:
❖
❖
❖
❖
In the Network Connections folder, double-click the Connection icon for
the dynadock's Ethernet adaptor, which is indicated by dynadock. This
The dynadock™ may not support VGA displays using Extended Display
Identification Data (EDID).
®
®
display.
®
The DVI or HDMI cable provides digital communication between the
display and computer, while the VGA cable provides analog communication.
If your display has a DVI or HDMI
to obtain finer resolution options.
The display cable can be connected/disconnected at any time without
disconnecting the dynadock™ from your computer.
If no output is seen on the display connected to the dynadock™, the current
video resolution setting may not be supported by the display. This can
happen if the display does not report its supported modes to the dynadock's
DVI component. Adjust the resolution of the external display until an image
appears. For more information, see
Utility" (page 24).
In Windows 8, press the (
Panel, Network and Sharing Center, and then Change adapter
setting.
®
In Windows 7, click Start, Control Panel, Network and
Sharing Center, and then Change adapter setting.
In Windows Vista
status and tasks, and then Manage network connections.
®
In Windows XP, click Start, Connect to, and then Show all
Connections.
out port
®
out port on the dynadock™:
®
cable (not included) into the HDMI
®
cable (not included) into the HDMI
®
port, use the DVI cable or HDMI
"Using the TOSHIBA dynadock™ U3.0
for more information.
) + Q keys, and then click Control
®
, click Start, Control Panel, View network
21
®
in
®
®
cable
"Adjusting