Crosscut Table - Grizzly G0451 Instruction Manual

Crosscut Table

Components and Hardware Needed:
Crosscut Table ...................................................1
Crosscut Table Brace .........................................1
T-Nut M8-1.25 .....................................................2
T-Nut M12-1.75 ....................................................1
Flat Washer 12mm .............................................1
Adjustable Handle M12-1.75 x 55 .......................1
Knob M8-1.25 x 50 .............................................2
Flat Washer 8mm ...............................................2
Tools Needed:
An Assistant .......................................................1
To install the crosscut table:
1.
Thread the M12-1.75 x 55 adjustable handle,
with a 12mm flat washer, through the cross-
cut table and into a M12-1.75 T-nut as shown
in Figure 33.
Figure 33. Installing the adjustable handle.
-26-
2.
With the help of an assistant, place the cross-
cut table on the pivot pin of the swing arm
and slide the T-nut into the T-slot in the slid-
ing table (see Figure 34).
Qty
Qty
Figure 34. Installing the crosscut table.
3.
Slide two M8-1.25 T-nuts into the crosscut
table brace.
4.
Align the T-nuts in the crosscut table brace
with the holes in the crosscut table and
thread the M8-1.25 x 50 knobs, with 8mm flat
washers, into the T-nuts as shown in Figure
35.
Figure 35. Installing the crosscut table brace.
Crosscut
Table Brace
G0451 14" Sliding Table Saw