Setting Of Recording Interval - CatCam Camera User Manual

7. Setting of Recording Interval

The available recording time which means memory capacity and battery energy can be spread
over a longer time. The following graphic shows this. If added together both bars have the same
length. Chopping the recording time into smaller pieces extends the coverage to a longer time.
One cycle consists out of a recording phase and a pause phase in which the camera is
switched off as shown in the following graphic. For both phases the time can be set on the
camera.
Record time
Setting these times is done using the On/Off button. While a quick push on the button is
switching the camera ON holding the button down enables time setup.
The procedure is as follows:

In the default state the camera is Off

Hold the button down until the status light blinks.

The status light comes on and blinks. Each blinking increases the recording time by 1
minute.

When the desired recording time is reached release the button.

Press the button again to set the pause time, each blinking increases the pause time by
1 minute.

When the button is released the settings will be stored and the camera switches into the
recording mode.
If you want a continuous recording without interrupts use the same procedure as before.
Release the button immediately after first blinking of the status light. It doesn't matter if you do
this at setting of recording time or pause time. In both cases the result is that the interval mode
is switched Off. As a feedback the status light will blink quickly several times.
continuously
Total recording time
Pause time .....
Video CatCam User Manual - Page 8 of 12
Interval