Asus A7N8X-VM User Manual page 21

2. Floppy disk drive connector (34-1 pin FLOPPY)
This connector supports the provided floppy drive ribbon cable. After
connecting one end to the motherboard, connect the other end to the
floppy drive. (Pin 5 is removed to prevent incorrect insertion when
using ribbon cables with pin 5 plug).
A7N8X-VM
A7N8X-VM Floppy Disk Drive Connector
3. ATX power connectors (20-pin ATXPWR1)
These connectors connect to an ATX 12V power supply. The plugs from the
power supply are designed to fit these connectors in only one orientation. Find
the proper orientation and push down firmly until the connectors completely fit.
A7N8X-VM ATX Power Connector
If you will need to replace the power supply in the future, make sure that your
new ATX 12V power supply can provide 8A on the +12V lead and at least 1A on
the +5-volt standby lead (+5VSB). The minimum recommended wattage is 230W,
or 300W for a fully configured system. The system may become unstable and
may experience difficulty powering up if the power supply is inadequate.
ASUS A7N8X-VM Motherboard
FLOPPY1
A7N8X-VM
NOTE: Orient the red markings on
the floppy ribbon cable to
PIN 1
ATXPWR1
+12.0VDC
+5.0VDC
+5VSB
+5.0VDC
PWR_OK
-5.0VDC
COM
COM
+5.0VDC
COM
COM
COM
+5.0VDC PS_ON#
COM
COM
+3.3VDC -12.0VDC
+3.3VDC +3.3VDC
PIN 1
1-13