Gigabyte GA-Z68XP-UD3-iSSD User Manual page 88

Step 3:
After entering the CREATE VOLUME MENU screen, enter a volume name with 1~16 letters (letters cannot
be special characters) under the Name item and press <Enter>. Then, select a RAID level (Figure 4). RAID
levels supported include RAID 0, RAID 1, Recovery, RAID 10, and RAID 5 (the selections available depend
on the number of the hard drives being installed). Press <Enter> to proceed.
Intel(R) Rapid Storage Technology - Option ROM - 10.5.0.1034
Copyright(C) 2003-11 Intel Corporation. All Rights Reserved.
Name :
RAID Level :
Disks :
Strip Size :
Capacity :
Sync :
[hi]-Change
Step 4:
Under Disks item, select the hard drives to be included in the RAID array. If only two hard drives are installed,
they will be automatically assigned to the array. Set the stripe block size (Figure 5) if necessary. The stripe
block size can be set from 4 KB to 128 KB. Once you have selected the stripe block size, press <Enter>.
Intel(R) Rapid Storage Technology - Option ROM - 10.5.0.1034
Copyright(C) 2003-11 Intel Corporation. All Rights Reserved.
Name :
RAID Level :
Disks :
Strip Size :
Capacity :
Sync :
[hi]-Change
Appendix
[ CREATE VOLUME MENU ]
Volume0
RAID0(Stripe)
Select Disks
128KB
111.7 GB
N/A
Create Volume
[ HELP ]
RAID0: Stripes data (performance).
[TAB]-Next [ESC]-Previous Menu
Figure 4
[ CREATE VOLUME MENU ]
Volume0
RAID0(Stripe)
Select Disks
128KB
111.7 GB
N/A
Create Volume
[ HELP ]
The following are typical values:
RAID0 - 128KB
RAID10 - 64KB
RAID5 - 64KB
[TAB]-Next [ESC]-Previous Menu
Figure 5
- 88 -
[ENTER]-Select
[ENTER]-Select