Electrolux ERN29600 User Manual page 11

1
5
Important! The wires in the mains lead are
coloured in accordance with the following
code:
1
Green and Yellow:
3
Brown:
5
Blue:
As the colours of the wires in the mains lead
of this appliance may not correspond with
the coloured markings identifying the termi-
nals in your plug, proceed as follows:
1. Connect the wire coloured green and yel-
low to the terminal marked either with the
letter "E" or by the earth symbol
coloured green and yellow.
2. Connect the wire coloured blue to the
terminal either marked with the letter
"N" or coloured black.
3. Connect the wire coloured brown to the
terminal either marked with the "L" or col-
oured red.
4. Check that no cut, or stray strands of wire
is present and the cord clamp
cure over the outer sheath.
5. Make sure the electricity supply voltage is
the same as that indicated on the appli-
ance rating plate.
6. Switch on the appliance.
The appliance is supplied with a 13 amp plug
2
fitted . In the event of having to change
2
3
4
Earth
Live
Neutral
or
4
is se-
the fuse in the plug supplied, a 13 amp ASTA
approved (BS 1362) fuse must be used.
Warning! A cut off plug inserted into a
13 amp socket is a serious safety
(shock) hazard. Ensure that it is
disposed of safely.
Door reversibility
The door of the appliance opens to the right.
If you want to open the door to the left, do
these steps before you install the appliance:
1. Loosen and remove the upper pin.
2. Remove the upper door.
3. Remove the spacer.
4. Loosen the middle hinge.
5. Remove the lower door.
6. Loosen and remove the lower pin.
On the opposite side:
1. Tighten the lower pin.
electrolux 11