Lindy 38124 User Manual page 6

User Manual
Deleting a Transmitter
1. Press Menu and then select Setup and press OK.
2. The following Menu will be displayed, select Remove a Transmitter and press OK.
3. Use the arrow keys to highlight the Transmitter you want to delete, then press OK to select the
transmitter and then OK again to confirm deletion.
Troubleshooting
The Wireless or Video Link LED is not lit
1. If the Transmitter and/or Receiver are positioned horizontally move them to the vertical position.
Switch both Extender units off and back on.
2. Reduce the distance between the Transmitter and Receiver units and then switch both Extender
units off and back on.
The screen is blank
1. Check that all connections are correctly made and that all units are powered on.
2. Check that the Wireless and Video Link LEDs are lit
The IR Extender does not work
1. Check that the IR Extender cable is correctly connected to the Transmitter unit.
2. Check that the IR Eye is visible and able to directly see your remote control.
3. Reposition the IR Flasher to another location near the IR port of your source device
The Extender says to check the video signal
1. Switch on your HDMI video source
2. Check that the HDMI cable between your HDMI source and the Transmitter unit is correctly
connected
5
English