Page 1
FUNDAMENTAL ACOUSTIC RESEARCH OWNER’S MANUAL ACTIVE MONITOR PEAK2 (V)
Page 2
FUNDAMENTAL ACOUSTIC RESEARCH Thank you for choosing the FAR PEAK2 (V) active two PEAK2 (V) way monitor. In order to obtain the best performance from this active monitor, please be sure to read this owner’s manual and use your speaker only in accordance with its instruction.
FUNDAMENTAL ACOUSTIC RESEARCH Thank you for choosing a FAR active monitor. This unit is The link functions the same as both of the inputs. Use the an exceptional product that will give you years of superb link to connect one speaker to another performance.
Crossover frequency 3500 Hz 6 dB/Octave High pass section Crossover frequency 6500 Hz 6 dB/Octave Bandpass filter 20-20000 Hz 6 dB/Octave Limitor (on/off) +2dB Components Woofer 14 cm / 5,5 inch Tweeter soft dome 1 inch OWNERS MANUAL PEAK2 (V)
Page 5
FUNDAMENTAL ACOUSTIC RESEARCH Listening position 50-120 Amplifier Specifications Power (PEAK) Woofer: Power Power (NOMINAL) Power @ 4 Ohm OWNERS MANUAL PEAK2 (V)
Page 6
Slew rate 35 V/µs SN ratio > 100 dB Distortion Intermodulation 0,01% Total 0,05% Input Sensitivity 0 dB Impedance > 10 kOhm Connectors Input (symmetric) XLR & Jack Link Remote RJ-45 External dimensions Height Width Depth Weight OWNERS MANUAL PEAK2 (V)
FUNDAMENTAL ACOUSTIC RESEARCH TECHNICAL DRAWING LEGEND 1. Main level tuning 2. Limitor function 3. Link 4. Input XLR 5. Mains 6. Power 7. Serial number 8. RCV connection OWNERS MANUAL PEAK2 (V)
FUNDAMENTAL ACOUSTIC RESEARCH Limitor function Rear panel level. The PEAK2 (V) has a built in limitor developed to protect Adjust the sound level by turning the main level knob to the drivers against harmful signals. The limitor acts the desired position.
Page 9
FUNDAMENTAL ACOUSTIC RESEARCH OWNERS MANUAL PEAK2 (V)
This section is designed to trouble free technical operation. Most of the problems encountered by the users are due to operating mistakes .Please support@far-audio.com check this list first for a possible solution. If the problem persists, consult your local FAR distributor or EMAIL to : Your problem is...
Page 11
In conjunction with the dedicated card, the remote will permit you to set the volume within 7 positions. Figure 3 : volume control Only available on PEAK2 (V) version. This information is written at the rear of your speaker close to the serial number.
Need help?
Do you have a question about the Peak2 and is the answer not in the manual?
Questions and answers