Advertisement
INSTALLATION AND OPERATING MANUAL
This manual must be read and the requirements carried out
SIG MARINE RESERVES THE RIGHT TO MAKE CHANGES TO PRODUCTS
QUALITY INSPECTED BY-
to ensure satisfactory performance.
OR DOCUMENTS AT ANY TIME
Doug & Don
Sig Marine Products
# 407-204 Cayer St. Coquitlam
B.C. Canada V3K 5B1
www.sigmarine.com
info@sigmarine.com
T: 800 659 9768
Nov 5/2008
DATE-
Advertisement
Table of Contents
Related Manuals for Sig Marine Solid Fuel Heater
Summary of Contents for Sig Marine Solid Fuel Heater
- Page 1 T: 800 659 9768 INSTALLATION AND OPERATING MANUAL This manual must be read and the requirements carried out to ensure satisfactory performance. SIG MARINE RESERVES THE RIGHT TO MAKE CHANGES TO PRODUCTS OR DOCUMENTS AT ANY TIME Doug & Don Nov 5/2008...
-
Page 2: Warnings And Disclosures
WARNINGS AND DISCLOSURES DO NOT ATTEMPT TO BURN OIL FUELS OR GAS FUELS IN THIS APPLIANCE CERTAIN BRANDS OF ENGENEERED FIREWOOD BURN WITH AN ENHANCED LEVEL OF HEAT. READ THE INSTRUCTIONS CAREFULLY AND REFRAIN FROM BURNING ANY MANUFACTURED WOOD WITH AN ARTIFICIALLY INCREASED BTU RATING. - Page 3 RECOMMENDED INSTALLATION REQUIREMENTS SOLID FUEL HEATER 45 Degree Elbows Maximum Stainless Steel Liner 1/2” Air Space Sliding Door Panel Drawer Damper Adjustment Fresh Air Inlet...
- Page 4 INSTALLATION LOCATION The solid fuel heater should be mounted on a bulkhead. The area available must be large enough to allow at least 8” of side clearance from combustible surfaces. It must be lined with high-density heat retardant insulation and finished with light gauge metal preferably stainless steel. Locate the heater as close to the floor as possible for maximum stack length and to provide good heat convection.
- Page 5 DECK FITTING FLUE CAP The “ DP” Cap or the “H” Cap is recommended. COMBUSTION AIR To guarantee that sufficient oxygen (fresh air) is available for your heater GOOD VENTILATION IS ESSENTIAL. It is necessary to replace the air inside your boat at the same rate as it is being consumed by the heater.
- Page 6 OPERATION Lighting Open the damper control on the front of the ash drawer by sliding the brass knob to the right. Close the sliding panel on the front door of the heater. The fire can be lit using any fire lighter or starter. IT IS IMPORTANT NOT TO OVERFILL THE COMBUSTION CHAMBER (pg 4).
- Page 7 If any part of your new product fails because of a manufacturing defect within the warranty period Sig Marine offers to replace said parts free of charge, provided, however, that such parts have not been improperly repaired, altered or tampered with or subjected to misuse, abuse or exposed to corrosive conditions.
-
Page 8: Warranty Form
Return to: #407 – 204 Cayer Street, Coquitlam, B.C. Canada V3K 5B1 WARRANTY FORM I have read and understand the Limited Warranty and the Instruction Manual and agree to the terms and conditions (please print) Date…………………………………………………………………..………… Purchaser’s Name…………………………………………………………….. Address……………………………………………………………………….. ……………………………………………………………………………..…... ………………………………………………………………………………..…...
Need help?
Do you have a question about the Solid Fuel Heater and is the answer not in the manual?
Questions and answers