Warranty; Troubleshooting - Klutch 1230080 Owner's Manual

Checking the Air Compressor Oil
1. Place Air Compressor on level surface. The oil level should be at the red dot on the Oil Sight Glass.
2. If oil level is low, remove Oil Breather Cap and add enough oil to bring the oil level to the red dot on the Oil
Sight Glass.
3. Replace Oil Breather Cap before starting compressor.
Changing the Air Compressor Oil
Note: This compressor uses only SAE 5W-30 motor oil.
1. Remove the Drain Plug under the Oil Sight Glass by turning the nut counter-clockwise with wrench. (See
Figure 1.)
Note: Oil will begin to drain as Drain Plug is loosened. Place a funnel and oil pan in place BEFORE loosening
Drain Plug.
2. Once Drain Plug is removed, tilt Air Compressor backwards to allow all of the oil to drain out of the crankcase.
3. Once oil is drained, replace Drain Plug and securely tighten in place with a wrench. Be careful not to
overtighten the Drain Plug, as this could damage the rubber seal.
4. Place Air Compressor on level surface.
5. Remove the Oil Breather Cap.
6. Slowly pour the oil into the Oil Fill hole, until the oil level rises to the center of the red dot on the Oil Sight Glass.
7. Install the Oil Breather Cap into the Oil Fill hole. Firmly hand tighten the Oil Breather Cap by turning clockwise.
Always inspect the tool before use, and make sure it is in good working condition. Make sure all air vents are
clear, (use compressed air to clean the machine where possible). Check the power cable to make sure it is
intact and free from cracks, bare wires etc. Avoid using solvents when cleaning plastic parts. Most plastics are
susceptible to damage from the various types of commercial solvents.

WARRANTY

One Year Warranty
TROUBLE
Tank does not hold air or does not
reach operating pressure
TROUBLE SHOOTING
POSSIBLE CAUSE
The air relief valve on the bottom
of the tank is not closed
7
CORRECTIVE ACTION
Close the air relief valve