Troubleshooting - American DJ Color Fusion User Instructions

Table of Contents

Advertisement

Color Fusion
Channel
Value
1
0 - 255
2
0 - 255
3
0 - 255
4
0 - 255
5
0 - 255
6
0 - 255
7
0 - 255
0 - 127
128 - 159
160 - 191
192 - 223
224 - 255
Channels 5 and 6 can be used with Channels 1, 2, 3, and 4.
Channel 6 is also used with Channel 7.
If the value of Channel 7 is above 128, Channels 1, 2, 3, 4, and
5 will not work, Channel 6 will control the speed of the Channel
7 Modes.
Color Fusion
This fixture is fitted with halogen lamps which are
highly susceptible to damage if improperly handled.
Never touch the inside lamp with your bare fingers
as the oil from your hands will shorten lamp life.
Also, never move the fixture until the lamp has had
ample time to cool. Remember, lamps are not cov-
ered under warranty conditions.
American DJ Supply
- www.americandj.com - Color Fusion Instruction Manual Page 9
©
®
DMX Values and Functions
Function
RED
GREEN
BLUE
COLOR MIXING
DIMMING CONTROL
0%
100%
STROBE AND SPEED CONTROL
SLOW
FAST
MODE
BLACKOUT
RAINBOW STROBE
SLOW RAINBOW FLUTTER
FAST RAINBOW FLUTTER
SOUND ACTIVE
Halogen Lamp Warning
Color Fusion
Lamp Replacement: Caution! Never open the unit when in use.
Always disconnect the main power before attempting to replace the
lamp. Remember always replace with the same type lamp and fuse.
1. Be sure to follow the proper procedures when handling
halogen bulbs.
2. Unscrew the two phillips screws located directly under the top of
the barn door hinge.
3. Pull the glass cover down, you will notice that it is connected with
hinges.
4. Remove the bulb(s) by either pushing the bulb up and pulling it out
or down and out. Replace the bulb with the same type of bulb.
5. Reassemble.
Color Fusion
Fuse Replacement: First uplug the power. Locate the fuse holder on
the back of the unit underneath the power cord. Insert a flat-head screw
driver into the power socket and unsecrew the fuse holder. Remove the
bad fuse and replace with a new one.
Color Fusion
Listed below are a few common problems the user may encounter,
with solutions.
No light from the unit:
1. Check the fuse in the back panel.
2. Check if the lamps are lit. If power is present but the lamps are
not lit, the lamp may need to be replaced.
Unit not responding to DMX:
1. Check that the DMX cables are connected properly and are
wired correctly (pin 3 is "hot"; on some other DMX devices
pin 2 may be 'hot'). Also, check that all cables are connected
to the right connectors; it does matter which way the inputs
and outputs are connected.
Unit does not respond to sound:
1. Quiet or high pitched sounds will not activate the unit.
If problems are not resolved; Contact American DJ® for service.
1-800-322-6337
American DJ Supply
- www.americandj.com - Color Fusion Instruction Manual Page 10
©
®
Lamp Replacement
Fuse Replacement
Trouble Shooting

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Color Fusion and is the answer not in the manual?

Table of Contents