System Menu - American DJ Ruby Royal User Instructions

Ruby Royal
American DJ - www.americandj.com - Ruby Royal Instruction Manual Page 11
© ®

System Menu

Ruby Royal
ADDR
1. Press the MENU button until "ADDR" is displayed, press ENTER.
2. "X" will now be displayed, "X" represents the displayed address.
Press the UP or DOWN buttons to find your desired address.
3. Press ENTER to confirm, then connect your DMX controller. To exit
without making any adjustments press the MENU button.
NOTE: If after you connect your DMX controller the unit does not fall
into DMX mode, press and hold the MENU button for at least 3 sec-
onds.
SLND -
tion.
1. Press the MENU button until "SLND" is displayed, press ENTER.
Either "SL 1" or "SL 2" will be displayed.
2. Press the UP or DOWN buttons until your desired setting is dis-
played, press ENTER to confim. To exit without making any adjust-
ments press the MENU button.
SHND: SH 0 - SH 18
run with or without sound active mode activated.
1
. Press the MENU button until "SHND" is displayed, press ENTER.
2. "SH X" will now be displayed, "X" representing a number between
0-18. Shows 1-18 are preprogrammed shows, while Show 0 is random
show mode. Press the UP or DOWN buttons to find your desired show.
3. Press ENTER to confirm, and then press and hold the MENU button
for at least 3 seconds to activate. To exit without making any adjust-
ments press the MENU button. When show mode is activated, you can
change the show without have to go through steps 1 & 2.
SOUN
1. Press the MENU button until "SOUN" is displayed, press ENTER.
2. Either "ON" or "OFF" will now be displayed. Press the UP or DOWN
- DMX Address Setting via control board -
Set a unit as a slave in a master/slave configura-
- Show modes 0-18. Show Mode can
- In this mode you can run in sound active mode.
American DJ - www.americandj.com - Ruby Royal Instruction Manual Page 12
© ®
System Menu