American DJ Accu UFO User Instructions page 11

Accu UFO
1. Access the main menu.
2. Tap the UP button until "SPEC" is displayed, press ENTER.
3. Tap the UP button until "DFSE" is displayed, press ENTER.
4. The display will show "ON/OFF".
5. Press the UP button to display "ON" to activate this function,
or "OFF" to deactivate this function.
6. Press ENTER to confirm.
7. Press MODE/ESC to return to the main menu.
When you exit this function, the unit will begin to reload
data.
FEED
- With this function you can switch the Pan/Tilt error
correction on and off. This will automatically correct the
Pan/Tilt if it is somehow moved out of place.
1. Access the main menu.
2. Tap the UP button until "SPEC" is displayed, press ENTER.
3. Tap the UP button until "FEED" is displayed, press ENTER.
4. Press the UP or DOWN buttons to select either "ON" to acti-
vate this function, or "OFF" to deactivate this function.
5. Press ENTER to confirm.
6. Press MODE/ESC to return to the main menu.
VER
- Use this function to display the Software version of
the unit.
1. Access the main menu.
2. Tap the UP button until "SPEC" is displayed, press ENTER.
3. Tap the UP button until "VER" is displayed, press ENTER.
American DJ - www.americandj.com - Accu UFO Instruction Manual Page 21
®
System Menu Accu UFO
4. The display will show "V-1.0", the display may also show, "V-
2.0", "V-9.9" etc.
5. Press MODE/ESC to exit.
ADJU
are aligned and to adjust any motors that are not.
1. Access the main menu.
2. Tap the UP button until "SPEC" is displayed, press ENTER.
3. Tap the UP button until "ADJU" is displayed, press ENTER.
4. Tap the UP button until "CODE" is displayed, press ENTER.
5. The display will show "CXXX", were as "XXX" represents the
calibration password. The calibration password is "C050." Use
the UP or DOWN buttons to enter the proper password.
6. Once the proper password is entered the display will read
"CHXX", were as "XX" represents the fixture channel number, in
the case of the Accu UFO 1~10.
7. Select the desired channel to be calibrated by pressing the
UP or DOWN buttons and then ENTER to confirm.
8. The display will then read "XXXX", were "XXXX" stands for
the calibrate values.
9. Adjust the desired calibration value between –128 and 127
by pressing the UP and DOWN. As you scroll up and down
through the calibration values you will
notice slight changes in the wheel or motor you are attempting
to calibrate.
10. Once you reach your desired calibration press ENTER to
confirm and lock in your calibration.
11. Once you are completely finished press MODE/ESC to
return to the main menu.
- Use this function is used to make sure all motors
American DJ - www.americandj.com - Accu UFO Instruction Manual Page 22
© ®
System Menu