Table of Contents
Advertisement
To install the strings using only the bridge:
1.
Slide the 1st string through the corresponding
hole in the bridge (Figure 29).
2.
Repeat Steps 3-8 in the previous subsec-
tion.
Figure 29. 1st string installed.
String Retainers
Components and Hardware Needed:
Guitar ................................................................. 1
Retainer ............................................................. 1
Stainless Steel Screw #2 x
Bushing .............................................................. 1
The string retainer mounts between the 1st and
2nd strings (Figure 30).
-20-
Qty
/
" .......................... 1
3
8
Figure 30. String retainer locations.
To install the string retainer:
1.
Place the string retainer on top of the 1st and
2nd string near the second tuner.
2.
Using a
⁄
" drill bit, drill
1
16
straight through the holes in the string retain-
ers.
Note: Drilling the holes deeper than
could result in drilling out the bottom of the
peghead.
3.
Slide a #2 x
⁄
" screw through a retainer and
3
8
small bushing, and fasten it to the back hole
on the headstock (Figure 30).
H8068 Telecaster
Retainer and
Bushing
⁄
" deep holes
1
4
⁄
"
1
2
Style Kit
®
Advertisement
Table of Contents
