Stove Guard Guardian 2010 Installation & Operating Manual

Guardian 2010 cooktop model - august 2011

Advertisement

Quick Links

Guardian 2010 Cooktop Model - August 2011
Thank you for your purchase. STOVE GUARD is an electronic safety device for use with electric stoves. It turns the stove
OFF when you forget by using the advanced technology found in security monitoring devices and a specially programmed
microcontroller.
STOVE GUARD controls the stove's electrical system to help prevent food and pots from burning , as well as reducing the
risk of fire caused by unattended cooking.
STOVE GUARD is preset at the factory at the highest fire safety setting of one minute.
Most Home Care Workers will set the Auto Timer to 5-7 minutes maximum.
This is the recommended setting for use by anyone with Alzheimer's or similar medical conditions.
  When properly installed, adjusted, and set in AUTO mode, STOVE GUARD will automatically shut the
electric cooktop stove OFF if no one is present in the monitored cooking area for a preset period of time.
  Upon returning to the cooking area, STOVE GUARD will detect their presence and automatically turn the
stove ON again. The preset time will reset to the last setting.
  STOVE GUARD can also be used in a TIMER mode to set a maximum cooking time; after the preset time
is reached, the stove will be turned OFF. The TIMER setting may be used to cook food for a preset time.
In Timer mode the Motion Sensor will not monitor the cooking area.
Installation of the STOVE GUARD COOKTOP Model requires a licensed Electrician to be wired properly according to
local electrical codes.
Do not disassemble any of the components. There are no user serviceable parts inside. Refer servicing to a qualified person
only.
DO NOT INSTALL
the EMU (Electronic Monitoring Unit):
  Directly above a heat source or where hot/cold air or steam will blow onto it;
  On or above a microwave or toaster oven;
  Directly on or above the stove;
Do not allow grease to build up on the sensing unit. This will reduce STOVE GUARD's sensing range, and possibly turn the
stove OFF even when someone is present in the kitchen.
Clean the outer surface of the EMU with a clean, damp cloth only. Do not use soaps or cleaning liquids.
STOVE GUARD must be tested with the individual who requires this device and adjusted to their personal needs, as
well as adjusted to the home environment of use to ensure proper functioning. Additional fire safety devices, such as
smoke detectors and fire extinguishers must also be used to ensure complete cooking fire safety.
Please Keep This Manual for Future Reference
IMPORTANT WARNING
IMPORTANT TECHNICAL SAFEGUARDS
INSTALLATION & OPERATING MANUAL
Page 1 of 8

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Guardian 2010 and is the answer not in the manual?

Questions and answers

Summary of Contents for Stove Guard Guardian 2010

  • Page 1 ON again. The preset time will reset to the last setting.   STOVE GUARD can also be used in a TIMER mode to set a maximum cooking time; after the preset time is reached, the stove will be turned OFF. The TIMER setting may be used to cook food for a preset time.
  • Page 2 3. Rocker Switch to Control 120V Power (Must be set during installation) 4. EMU cord opening Mounting Brackets Front Control cord to EMU View EMU - ELECTRONIC MONITORING UNIT STOVE GUARD AUTO SG OFF STOVE OFF GUARDIAN SENSOR TIME TIMER 9.
  • Page 3 (the stove doesn’t draw current). Turn on a burner. Stove Guard should detect current, display will show 01. Test the Stove Guard by standing out of the EMU's sensor detection area. After 1 minute, power to the stove burner should shut off.
  • Page 4 (1 minute is the factory-preset time). When the user re-enters the sensing area, approximately 10-12 feet (3-4m) line of site from the EMU, the Stove Guard will turn the stove back on and reset timer to the last preset time.
  • Page 5 The relay output can be used to trigger an external monitoring device whenever the Stove Guard disables the stove, such as a Phone Dialer or Alarm system. The buzzer in the Stove Guard monitor unit makes an audible signal at the same time as the relay output makes the change from open contact to closed (start buzzing) and goes back to open contact (stop buzzing).
  • Page 6   To RAISE the detection field when the EMU cannot be located higher, slowly turn the screw to the LEFT . 2. STOVE GUARD is not detecting the movements of the user because its location is set very high up; the user is very short, or seated in a wheelchair.
  • Page 7 FOR TECHNICAL SUPPORT PLEASE CONTACT STOVE GUARD INTERNATIONAL LTD. 126 O'Neil Cres., Saskatoon, SK, S7N 1W8, CANADA Ph: 1-888-607-8683 Email: techsupport@stoveguardintl.com...
  • Page 8 CABLE_TO_MONITOR SWITCH_DPDT 12V DC 10A - 250V AC Save on Security Title: POWER BOX Fail-Safe Project: Stove Guard File: POWBOXFS.PDF Page: Number: Date: September 2006. Rev. : NOTE: User has to add wires drawn in blue. Page 8 of 8...

Table of Contents