Table of Contents
Advertisement
General information
Maintenance
Cleaning the cabinet
• Use a soft cloth slightly moistened with a mild detergent
solution. Do not use a solution containing alcohol, spirits,
ammonia or abrasive.
Cleaning discs
• When a disc becomes dirty, clean it with a cleaning cloth,
wipe the disc from the center out. Do not wipe in circular
motion.
• Do not use solvents such as benzene, thinner commercially
available cleaners, or antistatic spray intended for analogue
records.
Caution on condensation
Condensation (of dew) may occur inside the unit
when there is a great diff erence in temperature
between this unit and the outside. This unit may
not function properly if condensation occurs. In this
case, leave the unit for a few hours and restart the
operation after the condensation has dried up.
Be specially cautious against condensation in the
following circumstances:
When this unit is carried from one place to another
across a large diff erence in temperature, when the
humidity in the room where this unit is installed
increases, etc.
30
C-717DV
A ' P I N K U J K P F F
To install speakers on a wall
Prepare commercially available wood screws.
9 mm
16 mm
1
On a stable pillar or wall, attach a pair of wood
screws at the same interval as the interval
between the wall-mount holes of speaker.
Screw attaching interval
Speaker: 120 mm
2
Fit the screws into the wall-mount holes on the
rear of the speaker.
¤
CAUTION
Be sure to observe the following points when installing the
unit on a wall. Otherwise, the product may drop and cause
damage or an injury.
• Check the strength of the wall before installation. Do not
install on a plywood or plaster board. If you have any doubt
related to the wall strength, please consult a specialist.
• Check that the screws are fit securely into the wall-mount
holes of the speakers.
• Even after installation, use care so that the speakers do not
drop due to an accidental contact, etc.
4 mm
Advertisement
Table of Contents
