Table of Contents
Advertisement
12-2012.fm Page 7 Tuesday, July 13, 1999 2:50 PM
Adjusting the Input Level
The input level controls let you adjust
the crossover to balance the sub-
woofer's sound level with the rest of
your autosound system.
Turn your autosound system up to a
normal listening level, then use a flat-
head screwdriver to adjust each
control until the subwoof-
PUT LEVEL
er is as loud as desired.
Caution: If you use the
input terminals and turn your auto-
sound system volume too high for the
crossover, you could damage the
crossover. To reduce this possibility,
set the
INPUT LEVEL
their midpoints.
Adjusting the Subwoofer
Bass Boost
The
SUBWOOFER BASS BOOST
trols let you boost 45, 80, or 120 Hz
subwoofer output by 12 dB to en-
hance low sounds when desired. Set
the
45Hz/80Hz/120Hz
appropriate position, then set
to
. To return to the normal bass
ON
setting, set
to
+12dB
OFF
MOUNTING THE
CROSSOVER
After you have correctly connected
the crossover and set the controls,
follow these steps to mount the cross-
over.
IN-
HIGH LEVEL
controls past
1. Using the crossover mounting
2. At each marked position, drill a
con-
selector to the
+12dB
3. Attach
.
holes as a guide, mark the posi-
tions for the mounting screw
holes at the desired location.
9
/
-inch (3.57 mm) hole.
64
Caution: Be careful not to drill
into anything behind the mounting
surface.
the
crossover
mounting location using the sup-
plied sheet metal screws, lock-
washers, and washers.
at the
7
Advertisement
Table of Contents
