Connecting Power - Optimus Electronic Subwoofer Crossover Owner's Manual

12-2012.fm Page 5 Tuesday, July 13, 1999 2:50 PM

CONNECTING POWER

1. Ensure the negative (–) cable is
disconnected from your vehicle's
battery.
2. Connect the crossover's
(ground) terminal to a metal part
of the vehicle's frame.
Caution: Do not connect the
ground wire to a non-metallic
(plastic) part, or to any part insu-
lated from the vehicle's frame by
a non-metallic part.
3. Connect the crossover's
(power) terminal directly to the
vehicle battery's +12 volt termi-
nal.
4. Connect your autosound sys-
tem's switched power lead wire
(usually orange) to the cross-
over's
turns the crossover on and off
when you turn your autosound
system on and off.
Note: If your autosound system
does not have a switched power
lead wire, connect the cross-
over's
REMOTE
in your vehicle's fuse box that
provides 12-volt battery power
only when the ignition is set to
ON or ACC.
5. Reconnect the cable to your vehi-
cle battery's negative (–) terminal.
GND
B+12V
REMOTE terminal. This
terminal to a point
5