Connections - Lipinski Sound L-505A User Manual

6. CONNECTIONS

Inputs/Outputs
•
Unbalanced: Typically used for consumer-grade electronic hook-ups and for
short cable runs if no RFI (Radio Frequency Interference) is a problem.
•
Balanced: Typically used for the Pro-Audio environment. It takes away radio
frequencies saturated densely populated areas, and from within an
environment with a large number of electronics. It also allows for much longer
cable runs.
Input Sensitivity:
Setting depends on the strength of audio coming from preceeding equipment
(in most cases from the preamplifier):
• Default: regular signal level
• High: 5 dB signal boost
Bi-amp:
Be sure to remove the spade on speaker connectors. One input, two
separate power amps, 300 Watts to 4 Ohm load each. Use two sets of speaker
wire: one speaker wire for A, and separate wire for B.
Connect wire A to one set of connectors, and wire B to the other.
Biamplification
uncomparably better than commonly used bi-wiring.
POWER
Auto: Starts 3-5 seconds after the music starts. 18 minutes shut off time
after music ends.
Hue Switch
The glass front panel can change colors. Use a small flathead screwdriver
to toggle switches.
Lipinski Sound Corporation|
significantly increases
Confidential Copyright © 2008
microdynamics and is sonically
16 | P a g e