Table of Contents
Advertisement
STANDARD MOUNTING
1. Please note the protective film on the door . This is to prevent scratching. Do not
peel off at this time.
2. Some fireboxes have a screen rail, and/or screen retaining clips, and it may be
necessary to remove them. See Figure I
3. Remove the door from the box, and place into the opening of the firebox (finished
side facing you), and align in position where it is to be installed. Make sure once
set in place, it is level and plumb. W e recommend you use a level to do this.
4. There are predrilled holes on the frame of the door , one in the middle of the top bar ,
and two on each upright.
5. Mark the above holes (#1 through #5) to be drilled as illustrated in Fig. II.
6. Remove the door from the opening, and using a 3/32" drill bit, drill the firebox
where you had just marked for holes #1 through # 5.
7. Carefully remove the protective film from the door frame.
8. Place the door back into the firebox opening and align the holes on the door frame,
with the ones you just drilled.
9. Use the #8 X 2" screws (Fig B) and fasten the door frame to the firebox.
10. Peel off any remaining protective film, and make sure you have removed all
packing materials.
Fig I
Fig II
Page 3
Advertisement
Table of Contents
