Battery Installation; Mounting Instructions - Kidde PI2000 User Manual

Hide thumbs Also See for PI2000:
Table of Contents

Advertisement

Available languages

Available languages

WIRES ON ALARM HARNESS CONNECTED TO
Black
White
Red

BATTERY INSTALLATION

See Maintenance (section 6) for battery installation
CAUTION! IF BATTERY REMINDER FINGER IS NOT HELD DOWN
IN THE BATTERY COMPARTMENT BY THE BATTERY, THE BAT-
TERY DOOR WILL NOT CLOSE, THE AC QUICK CONNECTOR
WILL NOT ATTACH TO THE ALARM, AND THE ALARM WILL
NOT ATTACH TO THE TRIM RING (SEE SECTION 6, FIGURE 8).

MOUNTING INSTRUCTIONS

CAUTION: THIS UNIT IS SEALED. THE COVER IS NOT
REMOVABLE!
1. Remove the trim ring from the back of the alarm by holding the
trim ring and twisting the alarm in the direction indicated by
the "OFF" arrow on the alarm cover.
2. After selecting the proper smoke alarm location as described in
section 1 and wiring the AC QUICK CONNECT harness as
described in the WIRING INSTRUCTIONS, attach the trim ring to
the electrical box (see figure 6).
3. Pull the AC QUICK CONNECTOR through the center hole in the
trim ring and mount the ring, making sure that the mounting
screws are positioned in the small ends of the keyholes before
tightening the screws.
4. Plug the AC QUICK CONNECTOR into the back of the alarm
(see figure 5), making sure that the locks on the connector snap
into place. Then push the excess wire back into the electrical
box through the hole in the center of the trim ring.
5. If you have finished all the WIRING, BATTERY INSTALLATION
AND TRIM RING MOUNTING STEPS, you can install the alarm
on the trim ring. Note: The alarm will mount to the trim ring in
4 positions (every 90 degrees).
Hot Side of AC Line
Neutral Side of AC Line
Interconnect Lines (Red Wires) of
Other Units in the Multiple
Station Set up

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents