Events - Axis M1114–E User Manual

AXIS M1114–E

Events

Events
The Axis product can be configured to perform actions when different events occur, for example, start a recording when motion is
detected. The set of conditions that defines how and when the action is triggered is called an Action Rule.
Available Action Rule triggers and conditions include:
Applications — use installed applications to trigger the rule, see
•
Detectors
•
Motion Detection — trigger the rule when motion is detected, see
-
- Tampering — trigger the rule when tampering is detected, see
Hardware
•
Network — trigger the rule if network connection is lost or restored.
-
Input Signal
•
Manual Trigger — trigger the rule using the Manual Trigger button in the Live View page, see
-
Live View Page, on page 7
and configuration.
• PTZ
Moving — trigger the rule when the camera view moves due to a PTZ operation. This can for example be used
-
as an additional condition to prevent an action rule triggered by motion detection to record video while the
camera view moves due to a PTZ operation.
- Preset Reached — trigger the rule when the camera stops at a preset position. This can be for example be used
with the Send Images action to upload images from the preset position.
• Storage
Available — trigger the rule when the storage device is unmounted or removed. This can for example be
-
used to send maintenance notifications.
Full — trigger the rule when the storage device is full. Under normal operation, the oldest recordings will be
-
overwritten to prevent the storage device from becoming full.
Locked — trigger the rule if the storage device is locked (write protected).
-
System
•
- System Initializing — trigger the rule when the product is being started. This can for example be used to send a
notification when the product restarts.
• Time
Recurrence — trigger the rule periodically, see
-
upload an image every 5 minutes.
Use Schedule — trigger the rule according to the selected schedule, see
-
Available actions include:
PTZ Control
•
Preset Position — go to a preset position.
-
- Guard Tour — start a guard tour, see
Applications, on page 25
. This can for example be used to validate actions during product installation
Recurrences, on page 28
Guard Tour, on page 20
26
.
Motion Detection, on page 22
Camera Tampering, on page 22
. This can for example be used to
Schedules, on page 27
.
.
.
Controls on the
.