ARS-2030L/2032 Manual
Chapter 5
Troubleshooting
5.1 About LCD
After you power up, if there is no display on the LCD, please check if the connection
of power cord is firm and the environment of power outlet is normal.
5.2 About Error Messages
During Copy, Test, Compare and Verify, etc. if you press ESC to abort, an error
message will appear on LCD. Abortion may cause the copy smart plus to hang up,
therefore you have to power on again.
If reading fails, an error message will appear on LCD. Please get a new source CD to
try again. If the copy smart plus hasn't detected any device after powering on, an
error message will appear on LCD.
5.3 About CD-ROM/CD Writers
If a CD-ROM or any CD writer cannot read, please confirm the format of the source
CD and examine if it is damaged.
Use any CD writer to read the source CD. If it works, the CD-ROM is probably
defective or not compatible with the source CD. Use a fine CD writer as the data
reader, and set the "Read Speed" at minimum.
5.4 About Buttons
If you press any one of the four buttons on the panel, but there is no response, it is
perhaps that the button cannot function well. Please inspect the jumper setting.
64