1. Introduction. Giant’s products are designed to provide years of recreation and enjoyment. The GIANT AC have been designed primarily as “All Conditions” Freeride bikes. However, in order to fully understand all the bicycle features, you must read this bicycle manual, the suspension fork and rear shock manuals provided by Giant and parts suppliers.
G. Fork rake [mm.] H. Trail [mm.] Wheel base [mm.] 1060 1080 1100 Front wheel travel (AC bikes) 90~130 mm. Rear wheel travel 5.3~6.6” or 135~165 mm. (*1) Effective seat tube angle: Angle of centerline bottom bracket - saddle (top of saddle 20cm above top seat tube, measured along the seatpost).
Page 6
DESCRIPTION REMARKS Q’TY PER BIKE Front triangle Seat stays Chain stays Lower shock mount 4-1 Fixing bolt M6x1x40mm. 1 pc. per set 2 pcs per set, 4-2 Washer 13.5x6.4x1.2mm. same as 8-2. 4-3 Nut M6 1 pc. per set Fixing bolt upper shock mount M8x1.25x65mm.
4. Rear suspension. The rear suspension for your Giant AC bicycle / frame kit is provided by a Manitou Swinger SPV 3-way adjustable coil spring shock. For a description of the coil spring shock, see http://www.answerproducts.com or the Manitou owner’s manual that comes with your bike or frame kit.
Softer and stiffer spring rates are available for these rear suspension shocks either through your authorised Giant dealer or directly from the manufacturer (Manitou). If you need to change your spring, contact your local authorised Giant dealer or the Giant importer in your country.
WARNING: Do not try to disassemble or to replace the rear shock coil spring by yourself! Improper (dis)assembly may result in damage to the bicycle or in an accident which can cause serious injury or death. Only an authorised Giant dealer should replace the coil spring. 4-4 Removing the rear shock assembly or pivots.
5-1 Assembly. The AC chain tension device is designed to be easily installed and removed to/from the frame. It can be installed with all 3 chain rings (chain on the largest ring) or a single chain ring on the crank arm.
6. Tightening torque. The bolts used for the rear suspension (rear shock and pivots) are high-grade products and have been tightened in the factory with specific torque. If it is necessary to remove or tighten the bolts, extreme care should be taken when re-tightening them. All bolts should be cleaned and re-set using Loctite primer (#7649) and Loctite blue Removable...
7. Cleaning and maintenance. Proper maintenance of a Giant AC bicycle is important to insure years of trouble free safe riding and enjoyment. We recommend taking this bike to your authorised Giant dealer for periodic service and inspection of suspension systems. Parts such as seals, elastomer bumpers and bearings can be adversely affected by use, dirt and ultraviolet radiation.