Specifications; Troubleshooting - JBL ON STAGE 200ID User Manual

SPECIFICATIONS

™*
JBL ON STAGE 200ID
Frequency Response: 40Hz – 20kHz
Power Consumption: 20W maximum
Power Input: 12V/1.25A
JBL On Stage 200ID Transducer: 1-3/8" (35mm) x 2
(full range per channel)
Dimensions: 14-1/8" x 4-5/16" x 2-1/2"
(W x D x H) (359mm x 110mm x 64mm)
Weight: 1.5 lb (0.7kg)

TROUBLESHOOTING

Symptom Possible Problem
No sound from the No power to the system.
JBL On Stage 200ID Power adapter plug is not inserted
speaker system. correctly.
No volume or low volume.
Input source is low.
iPod/iPhone paused.
No power; green LED Wall adapter is not plugged into
is not on. the JBL On Stage 200ID system
correctly.
Wall adapter is not receiving
AC power.
Error message: "Device is iPhone has an old fi rmware
not iPhone Compatible" is version.
displayed on iPhone after
docking on the unit.
Solution
Ensure that the power supply is connected to a live power
source and is properly connected to JBL On Stage
(Note: When the JBL On Stage 200ID system is powered,
a green power LED should light up.)
Touch the volume "Up" (+) pad on the volume control
to unmute and/or increase the system volume level.
(Note: Touching the volume "Down" [–] pad lowers the
system volume; touching both the [+] and [–] volume
control pads at the same time will mute the system.)
Increase the volume level on the audio source device.
Press the Play button on the iPod/iPhone or remote control.
Check the connection of the wall adapter.
Place the wall adapter in a known powered outlet;
test the outlet with a lamp or other device.
Connect the JBL On Stage 200ID system to a known audio
source; test the audio source with headphones.
Upgrade iPhone fi rmware to latest version.
Undock & re-dock iPhone in unit.
WWW.JBL.COM
™* 200ID.
5 5