Hifonics Titan TSi600-IV Owner's Manual page 18

ENG| INSTALLATION INSTRUCTIONS
BEFORE THE CONNECTION
For the professional installation of a sound system appropriate wiring kits are available in car audio retailer stores. Attend the sufficient
profile section (at least 20 mm
remove rust-streaked and oxidized areas on the contact points of the battery and the ground connection. Make sure that all screws are
fixed tight after the installation, because loosely connections may cause malfunctions, insufficient power supply or interferences.
GND
1
Connect this GROUND terminal with a suitable contact ground point on the vehicle's chassis. The ground wire must be as short
as possible and must be connected to a blank metallic point at the vehicle's chassis. Ensure that this ground point has a stable
and safe electric connection to the negative "–"pole of the battery. Check this ground wire from the battery to the ground point if
possible and enforce it, if required. Use a ground wire with a sufficient cross section (at least 20 mm
plus (+12V) power supply wire.
REM
2
Connect the turn-on signal (e.g. automatic antenna) or the turn-on remote signal of your headunit with the REM-terminal of the
amplifier. Use therefor a suitable cable with a sufficient cross section (0,5 mm
with your headunit.
If your headunit doesn't provide a separate remote turn on wire and has no pre-amplifier low level RCA outputs, please refer to
the section AUTO TURN ON on page 20.
+12V
3
Connect the +12V-terminal with the +12V pole of the vehicle's battery. Use therefor a suitable cable with a sufficient cross section
(at least 20mm
be shorter than 30 cm. Do not install the fuse into the fuseblock until the installation is accomplished.
FUSE
4
The inserted fuses protect the amplifier from shorts and capacity overload. Replace damaged fuses only with equal fuses with
the same fuse rating (check the specifications).
LOGO BADGE
5
This switch changes the illumination color of the upper logo badge (blue or white). Follow by any means the directives of your
national road traffic regulations.
ELECTRICAL INTERCONNECTION
1 2 3
), the suitable fuse rating and the conductivity of the cables when you purchase your wiring kit. Clean and
2
) and install a additional in-line fuse. For safety reasons the distance between the fuseblock and the battery must
2
4 5
). Thereby the amplifier will turn on or off automatically
2
18
) and the same size like the
2