Connecting To Your Video Cassette Recorder; Inserting Batteries In The Remote Control - Topfield TF 5010 PVR User Manual

To use the RF connector

2.4.3 Connecting to your video cassette recorder

2.4.4 Inserting batteries in the remote control

If your television does not have any video and audio input,
you will need to use the radio frequency output from the dig-
ital receiver.
Tune your television to channel 36 (or rarely 43) so that you
can see the output from the digital receiver.
The digital receiver can also output video to another appliance
such as a video cassette recorder or video receiver through an
auxiliary SCART connector.
To insert the batteries, open the battery compartment by re-
moving the lid, and then insert the batteries observing the po-
larity, which is marked on the base of the battery compart-
ment.
If the digital receiver no longer reacts properly to remote con-
trol commands, the batteries may be flat. Be sure to remove
2.4 Connecting up your digital receiver 15
In this case, you will need to connect a ca-
ble from the RF OUT socket to the antenna
connector on your television. To ensure your
television can also pick up existing analogue
channels as well, you will need to connect a
cable from your television antenna to the RF
IN connector.
You will need to obtain a SCART cable to
use the auxiliary SCART connector. Plug
one end of the cable into the VCR socket on
the digital receiver, and the other end into
the matching socket on your video cassette
recorder or suchlike.