Changing The User Password; Changing The Supervisor Password; Resetting The Cmos To Default Settings; Exiting And Saving - Wyse Mobile Thin Computer User Manual

Using the BIOS Setup Utility

Changing the User Password

With a User Password, you can enter the Setup Utility and change or remove the User
Password, but you cannot enter the Setup Utility and change or remove the Supervisor
Password, or enable diskette access if it has been disabled.

Changing the Supervisor Password

A Supervisor Password must be set before a lower-level User Password can be set.
To set a Supervisor Password:
1. Select Change Supervisor Password and press Enter.
2. You will be prompted for the new Password, and then again to verify it. Type in six (6)

Resetting the CMOS to Default Settings

The main page provides the system parameters for you to reset the CMOS to default
settings.
After you enter this page, to select the Load Optimal Defaults: Select OK to reset the
CMOS to default settings.
Figure 5-6 Load Optional Defaults?

Exiting and Saving

To exit the BIOS setup utility select one of the following options:
•
•
or fewer keystrokes.
Note
If you make an error, press Esc to start over.
Load Optional Defaults?
[OK]
Save Settings and Exit - Select this option to save changes to the field values, and
then restart the thin computer using the new values. Press F10 from any of the menu
screens also allows you to save settings and exit.
Exit Without Saving - Select this option to discard any changes you have made to the
field values, and restart the thin computer using the old values.
[Cancel]
33