Ice Maker (Optional); Ice Maker Operation - Norcold 121X AC Series Owner's Manual

NOTE: Push and release the MODE button [4] to show "AC", the current mode of operation, in the center display for 10 seconds.
- If 120 volts AC is not available to the refrigerator:
- The fault codes "no" "AC" shows in the center display and an audible alarm sounds.
If 120 volts AC is available to the refrigerator, but is not operating correctly:
- A fault code shows in the center display.
- An audible alarm starts.
- Refer to the "Fault Codes" section of this manual.
- If 120 volts AC is not available to the refrigerator:
- The fault codes "no" "AC" shows in the center display and an audible alarm sounds.
If 120 volts AC is available to the refrigerator, but is not operating correctly:
- A fault code shows in the center display.
- An audible alarm starts.
- Refer to the "Fault Codes" section of this manual.

Ice Maker (Optional)

The ice maker is assembled to the refrigerators at the factory as optional equipment. If the refrigerator does not have a factory installed
ice maker, one cannot be added to the refrigerator at a later time.
The ice maker is fully automatic and will operate in ambient temperatures as low as 0° F. To allow operation at temperatures between
0° F and 32° F., the ice maker has a heater on the solenoid water valve and on the water line between the solenoid valve and the ice
maker. At temperatures below 0° F, store the ice maker as written in the "Ice Maker Storage" section of this manual.
!
CAUTION:
The water line heater does not protect the water supply line from the vehicle shut off valve to the solenoid valve on
the back of the refrigerator.
When the freezer temperature of the refrigerator is low enough, the ice maker opens the water solenoid valve and fills the mold. The
ice maker ejects the frozen ice into a storage bin. As the storage bin fills, the ice raises the shut-off arm until it turns off the ice maker.
As you use the ice and lower the ice level in the storage bin, the shut-off arm also lowers. This turns the ice maker ON and begins the
process of making ice.
The ice maker operates on:
- Cold potable water at a pressure of 15 psi - 125 psi.
- 120 Volts AC (108 VAC min. - 132 VAC max.).

Ice maker operation:

1. Make sure the ice maker AC power cord is plugged into a receptacle.
2. Open the water shut off valve of the vehicle.
NOTE: Make sure that the ice maker arm can move freely and does not touch the frozen foods in the freezer.
3. Push the ice maker arm down to the ON position [60] (See Art01015).
!
CAUTION:
If you operate the refrigerator without connecting the water supply line and/or opening the water shut off valve of
the vehicle, make sure the ice maker arm is up in the OFF position.
Owner's Manual 8