EnGenius EOC1650
Internet Connection Type: Select PPPoE from the drop‐down list.
MTU: The Maximum Transmission Unit (MTU) is a parameter that determines the largest
packet size (in bytes) that the router will send to the WAN. If LAN devices send larger
packets, the router will break them into smaller packets. Ideally, you should set this to
match the MTU of the connection to your ISP. Typical values are 1500 bytes for an Ethernet
connection and 1492 bytes for a PPPoE connection. If the router's MTU is set too high,
packets will be fragmented downstream. If the router's MTU is set too low, the router will
fragment packets unnecessarily and in extreme cases may be unable to establish some
connections. In either case, network performance can suffer.
Login: Specify the user name which is provided by your ISP.
Password: Specify the password which is provided by your ISP, and then verify it once again
in the next field.
Service Name: Specify the name of the ISP.
Type: Select a reconnection type: Keep Alive (A connection to the Internet is always
maintained), Connect on Demand: You have to open up the Web‐based management
interface and click the Connect button manually any time that you wish to connect to the
Internet.
Domain Name Service: Select Get Automatically from ISP if the ISP will provide the DNS
address, if not, select Use these DNS servers and specify the primary and secondary DNS
server IP address.
Click on the Apply button to save the changes.
Wireless Access Point / Client Bridge
Version 2.0
61