•
Pressing the SET and MODE button together to enter
TEST MODE, the LCD will display the word
t E S t
"
".
•
Whilst in test mode, each time the PIR sensor is triggered a
red indicator behind the PIR lens will flash to indicate a
trigger. Walk around the coverage area to determine if your
camera is suitably mounted.
•
Adjust the position of your VL1 if necessary and repeat
testing until the desired coverage area is achieved.
•
When you have completed the coverage area testing, press
the MODE and SET button together again to leave the
TEST MODE.
•
The VL1 will start a 60 seconds count down again.
•
Alternatively, when you have finished testing if you leave
the VL1 for approximately 5 minutes it will automatically
begin the 60 seconds count down.
•
Please leave the coverage area within 60 seconds to avoid
being photographed or videoed.
© Securesight 2007 E&OE
21