To Operate Trimmer; Taking Care Of Your Trimmer; Oiling The Blades; Blade Care - Conair THE CHOPPER HCT420CSC Instructions For Care And Use

TO OPERATE TRIMMER

1. Make sure unit is "off". Remove wide
clipper blade by simply placing your thumb
in front of the blade and pushing back until
the blade detaches. Use cleaning brush to
remove any loose hair before attaching the
trimmer blade. Attach the narrow blade from
the back, (lining it up with the small tab) and
then push forward until the blade snaps into
place. Be sure that the taper control is set
to the lowest setting (switch will be down
from the blade) before replacing the blade.
To begin trimming, push the taper control
switch up to its highest setting.
2. To trim your mustache, comb hair in the
direction of growth. Push the taper control but-
ton to its highest setting. Trimming only works
in this setting. Hold trimmer in an upright posi-
tion and bring the tip of the blade straight into
the mustache to trim.
3. To clean the trimmer, turn unit to "OFF"
position. Using your thumb, press upwards
against the blade. This will make it easy to
clean. Brush or blow hair clippings from the
cutter blade.
4. Again, snap in the blade set until you hear
a click. Be sure that the taper control is set to
the lowest setting (switch will be away from
the blade) before replacing the blade. This
trimmer attachment works well on sideburns
& necks as well as goatees and short beard
styles and mustaches. For thick, full beards
we recommend using the clipper blade.

TAKING CARE OF YOUR TRIMMER

OILING THE BLADES

About once a month you should oil the trim-
mer blades with the oil provided in your kit. It
is best to do this over a piece of newspaper.
Turn the trimmer on and hold it so that the
blades are pointed downward. Spread one
drop of oil across the blades, then turn the
trimmer off and wipe away the excess oil
with a soft cloth.
Be careful not to use too much oil and don't
oil your trimmer more than necessary, as this
could damage the motor. (Never attempt to oil
the motor bearing, as it is permanently lubri-
cated.) KEEP OIL AWAY FROM CHILDREN.

BLADE CARE

Because the trimmer blades are precision-
made for a very special use, they should
always be handled with care. Each time you
finish using the trimmer, take the cleaning
brush provided and brush away any loose
hair that has collected in the blades. Then
store the trimmer in its case to protect the
blades until the next use.
Be especially careful when changing or adjust-
ing blades.
To promote the long life of the appliance,
use your trimmer blade only for the purpose
intended by the manufacturer – to trim your
beard and mustache.