Trailer Towing; Tire Pressure Monitor; Resetting The Oil Life System - Buick Enclave 2008 Getting To Know Manual

Hide thumbs Also See for Enclave 2008:
Table of Contents

Advertisement

Trailer Towing

The Tow/Haul mode
(if equipped) assists
when pulling a heavy
trailer by reducing the
frequency of trans-
mission shifts and
improves the control of vehicle speed.
To turn on this feature, press the
(Tow/Haul) button located on the center
console in front of the shift lever. Press it
again to turn off the feature.
See Section 4 of your Owner Manual.

Tire Pressure Monitor

The Tire Pressure Monitor alerts you
when a significant reduction in pressure
occurs in one or more of your vehicle's
tires by illuminating the
Pressure) warning light on the instru-
ment panel. The low tire pressure warn-
ing light will remain on until you correct
the tire pressure.
A CHECK TIRE PRESSURE message
may appear on the DIC.
Correcting the Tire Pressure
When the low tire pressure warning light
illuminates, you must fill the tire to the
proper tire inflation pressure. The Tire
and Loading Information label, located
on the center pillar below the driver's
door latch, shows the correct inflation
pressure for the tires when they're cold.
"Cold" means your vehicle has been
sitting for at least three hours or driven
no more than one mile.
You can temporarily remove the DIC
message by acknowledging it with your
DIC controls. However, at the next
vehicle startup, the DIC message will
reappear if the tire pressure has not
been corrected.
You may notice during cooler conditions
that the low tire pressure warning light
will appear when the vehicle is first
started and then turn off as you start to
drive the vehicle. This could be an early
indicator that your tire pressures are
getting low and need to be inflated to
the proper pressure.
See Section 5 of your Owner Manual.
(Low Tire
The Oil Life System calculates engine
oil life based on vehicle use and dis-
plays CHANGE OIL SOON in the Driver
Information Center (DIC) when it's
necessary to change your engine oil
and filter. The Oil Life System should be
reset to 100% only following an oil
change.
To reset the Oil Life System:
1. Turn on the ignition, with the engine
2. Press the
3. Press and hold the
4. Turn off the ignition.
See Section 5 of your Owner Manual.
Note: The Tire Pressure Monitor can
alert you about low tire pressure, but it
doesn't replace normal monthly tire
maintenance.

Resetting the Oil Life System

off.
(Vehicle Information)
button until the DIC displays OIL LIFE
REMAINING.
button until 100% is displayed.
23
(Set/Reset)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents