X10 XPMT4 Owner's Manual page 8

Setting up the Lamp Module
Setting The Lamp Module's Code
(Modules sold separately)
Using a small screwdriver, set the red Letter
Code dial to the same Letter Code as your
Digital Clock Timer. Set the Black Number
Code dial to any unused number.
Ratings
The Lamp Module can be used to control an incandescent lamp rated up to 300W. It is
NOT suitable for other types of lamps such as fluorescent or energy saving lamps, low
voltage lamps, or lamps that include a dimmer control. Caution: Do not connect an
appliance such as a coffee pot or heater to a Lamp Module. It may damage the Module
and/or the appliance and could cause a fire hazard. Use an Appliance Module instead.
1. Set the Letter Code 2. Plug a lamp into
and Number Code. the Module.
Testing The Lamp Module
Make sure the lamp's switch is on. Plug the Module into the same wall outlet as your
Digital Clock Timer, press the ON and OFF buttons on the Digital Clock Timer that
correspond to the Number Code setting on the Module. If the Module turns On and Off
you can unplug the Module or Digital Clock Timer and move it to its permanent
location. If you can't control the module, contact www.x10pro.com/support for help.
NUMBER CODE
DIAL
1
15 3
13 5
11 7
9
A
O C
M E
K G
I
LETTER CODE
DIAL
AGC LAMP MODULE
3. Plug the Module into
the same wall outlet
as your Controller
(see testing below).
14
Setting up the Appliance Module
Setting The Appliance Module's
Code (Modules sold separately)
Using a small screwdriver, set the red Letter
Code dial to the same Letter as your
Digital Clock Timer. Set the Black Number
Code dial to any unused number.
Ratings
The Appliance Module can be used to control an incandescent lamp rated up to 500W.
However, due to the nature of inductive loads (those using transformers to step down
voltage to a lesser operating voltage, i.e.12VAC) up to 15A loads may be plugged into
the Appliance Module (such as Landscape Transformers or other low-voltage lighting
systems).
1. Set the Letter Code 2. Plug an appliance
and Number Code. into the Module.
It can also control other types of lamps such as fluorescent or energy saving lamps,
low voltage lamps, or lamps that include a dimmer control. And of course it can be
used to control appliances. Caution: Observe the ratings on the label on the back of
the Appliance Module.
Testing The Appliance Module
Make sure the appliance's switch is on. Plug the Module into the same wall outlet as
your Digital Clock Timer, press the ON and OFF buttons on the Digital Clock Timer that
correspond to the Number Code setting on the Module. If the Module turns On and Off
you can unplug the Module or Digital Clock Timer and move it to its permanent
location. If you can't control the Module, contact www.x10pro.com/support for help.
UNUMBER CODE
DIAL
1
15 3
13 5
11 7
9
A
O C
M E
K G
I
LETTER CODE
DIAL
AGC APPLIANCE MODULE
3. Plug the Module into
the same wall outlet
as your Controller
(see testing below).
15