X10 XPMT4 Owner's Manual
X10 XPMT4 Owner's Manual

X10 XPMT4 Owner's Manual

Digital clock timer
Hide thumbs Also See for XPMT4:

Advertisement

PRO
Model XPMT4
Digital Clock Timer
Owner's Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the XPMT4 and is the answer not in the manual?

Questions and answers

Summary of Contents for X10 XPMT4

  • Page 1 Model XPMT4 Digital Clock Timer Owner's Manual...
  • Page 2: Table Of Contents

    Before you begin Reviewing timer events ................10 Keep in mind that your X10 PRO System will always turn lamps and appliances on or off If the display shows FULL ............... 11 the instant you press the buttons. That’s obvious - but there can be some unexpected Selector switch ..................
  • Page 3: Introduction

    * Bright/Dim Commands are not stored in the memory, this is for direct manual operation only. your X10 PRO Modules, so you CANNOT replace it with a regular 12V power supply. 4. Alarm. The number 1 button also sets the time for the internal alarm buzzer.
  • Page 4: How To Program A Timed Event

    With each press the display shows whether you've selected Once, or Security. If neither Once nor Security is displayed, the 1. Install and set up all of your X10 PRO Modules referring to the instructions included event happens at the same time every day.
  • Page 5: Programming On And Off Times

    Setting up the Digital Clock Timer Programming ON and OFF times Setting something to happen every day at the same time Setting a timed event to occur Once only After you have installed all of your Modules and checked that they are working instantly If (within 4 seconds after setting an On or Off time) you press the “Mode”...
  • Page 6: Reviewing Timer Events

    Programming ON and OFF times Programming ON and OFF times Reviewing timer events If the display shows FULL If FULL is displayed when you try to enter a programmed time, this means that you have Set the Mode Switch in the “Prog Set/Review” position. If no events exist in memory 0:00 tried to enter an additional time when you have already used up all the available is displayed, otherwise the first event found in memory is displayed.
  • Page 7: Alarm Settings

    Changing the Letter Code To Cancel/Snooze the wake-up alarm When you first plug in the Digital Clock Timer it controls X10 PRO Modules set to Letter Code A.. If you want to change the Letter Code: When the alarm sounds at the time you have set, you can cancel it in one of two ways: 1.Slide the Buzzer switch to the OFF position.
  • Page 8 Setting up the Lamp Module Setting up the Appliance Module Setting The Lamp Module’s Code Setting The Appliance Module’s UNUMBER CODE NUMBER CODE DIAL DIAL (Modules sold separately) Code (Modules sold separately) Using a small screwdriver, set the red Letter Using a small screwdriver, set the red Letter Code dial to the same Letter Code as your Code dial to the same Letter as your...
  • Page 9: Troubleshooting

    Timer your programmed times will be protected for up to 48 hours in the event of a PHC06 which lets you use any touch tone telephone to call home and control X10 PRO power outage. The backlight and the buzzer do not operate when the unit is running on Modules.
  • Page 10 (2) years from the original date of purchase at retail. X10 agrees to repair or replace, at its sole discretion, a defective X10 product if returned to X10 within the warranty period and with proof of purchase.
  • Page 11 X10 PRO, North Las Vegas, NV 89032 www.x10pro.com Made in China XPMT4-10/08...

This manual is also suitable for:

Pro xpmt4

Table of Contents