Mitsubishi Electric TN810 ATX User Manual page 9

     
               
   

Form factor
Processor
Core logic
Cache
Memory –
RAM
Memory -
Flash ROM
Buses
VGA
Audio –
controller
Hard Disk &
CD-ROM
Floppy Disk
Parallel Port
Serial Ports
USB
Ethernet
Keyboard &
Mouse
Security
Power
Management
System
Management
Plug & Play
Battery back-
up
PCB
MITSUBISHI ELECTRIC MOTHERBOARD DIVISION
ATX, 12.0" wide x 7.8" deep. ATX 2.01 compliant.
Socket370 with the VRM8.2 regulator on motherboard.
Accepts 66/100Mhz Celeron™ processors
Intel 810
L2 cache included on processor module.
Memory sockets accept 168 pin un-buffered PC100 SDRAM modules.
4Mb Firmware Hub
5 PCI bus master slots, 1 shared PCI/ ISA slot, 1 ISA (No LAN fitted)
5 PCI bus master slots, 2 ISA slots ( LAN fitted)
Integrated Graphics controller (82810) with 2D/3D acceleration, 230Mhz
RAMDAC and optional 4Mb Display Cache (82810-DC100)
AC'97 2.1 compliant CODEC (Optional)
Dual UltraATA33/66 interfaces for hard disk and CD-ROM.
720kB, 1.2MB (3-mode), 1.44MB 3½ drives, 1.2MB 5¼ drives.
Support for 120MB drives via ATA port.
IEEE 1284 (ECP & standard) on 25-way D-type
Single 16550. One 9-way D-types on rear edge of motherboard.
Two ports.
1x RJ45 port
PS/2-style connectors.
Chassis intrusion detection. (optional)
Green and deep green via system management mode.
ACPI compatible.
Wake-on LAN
Standby option with wake-up on interrupt, serial port activity or button.
Hardware monitoring – Fan monitor (standard), Voltage/ Thermal monitor
(optional - PC87366 I/O)
PC98 and PC99 compliant
On-board lithium coin cell with 5 years typical life.
4-layer ATX form-factor.
All components on top side
         
PAGE 9 OF 46