Next Steps; Download And Install Latest Software - Watchguard SSL 100 Quick Start Manual

Next Steps

Congratulations! You have finished basic network setup of your WatchGuard SSL 100.
You can now put the WatchGuard SSL 100 in your network and use the WatchGuard SSL
Web UI to continue configuration, management, and monitoring tasks.
If you configured your WatchGuard
SSL in Single Interface mode...
• W hen you put the WatchGuard SSL
in your network, make sure you
connect to Eth0. Eth1 is available
only during the Quick Setup
Wizard.
• R eset the IP address on your
computer.
• T o connect to the WatchGuard
SSL Web UI, open a web browser
and type: https://[Eth0 IP
address]:8443
If you did not upload your feature key in the wizard, you can get your feature key at
https://www.watchguard.com/archive/getcredentials.asp. From the Web UI, go to Monitor
System > Feature Key to upload it.

Download and Install Latest Software

• G o to www.watchguard.com/archive/softwarecenter.asp
• F ind and download the latest version of WG SSL OS.
• F rom the Web UI, go to Manage System > Device Update.
For more information about how to configure your WatchGuard SSL 100, go to
www.watchguard.com/help/documentation and open the current help system.
If you configured your WatchGuard
SSL in Dual Interface mode...
• W hen you put the WatchGuard SSL
in your network, make sure you
connect both Eth0 and Eth1.
• R eset the IP address on your
computer.
• T o connect to the WatchGuard
SSL Web UI, open a web browser
and type: https://[Eth1 IP
address]:8443