Features And Benefits; Assembly - Vornado Whole Room Air Circulator Owner's Manual

Features and Benefits

Feature Benefit
With multiple speeds, any circulation need will be met.
To turn on unit - rotate knob one position clockwise.
Turn the knob clockwise to decrease airflow. Turn coun-
terclockwise to increase airflow. On models equipped
with push button speed controls: Press Power, then select
Multiple Speeds
speed.
Provides movement of air at any angle–up stairs, down a
hallway, room to room and everywhere in between.
Models V102, 270, 573, 673 and 679 provide movement
of air in two positions - vertically or horizontally.
Directable Airflow
Saves energy by maximizing the performance of heating
and cooling systems. When you use a Vornado Air
Circulator, you will not have to set your summertime
72
thermostat as low or your wintertime thermostat as high.
Energy Savings
(Model 783 and 795 only)
28" or 40" heights make this model perfect for out-
of- the-way placement behind furniture and office fur-
nishings. The extension tube must be used to achieve
the 40" height. To shorten the height of the circulator,
Adjustable Height
remove the extension tube. (See the Adjustable Height
assembly instructions in the shipping carton.)
Installing Protective Feet
Use the feet to protect floors when using your air circulator on uncarpeted
surfaces such as hardwood, vinyl, or tile. The feet are simple to install and will
help maintain the whisper-quiet operation.
Cushion Ring Feet
(Models 723, 745, 783 and 795 only)
The cushion ring feet are packaged separately
in the box. To install, roll or clip all feet onto the
base and space evenly. For balanced support it
is recommended to use 4 ring feet.
Cushion Pads
(Model 733 and 735 only)
Use guide marks on base bottom for location.
1. Place 4 pads over the 4 edge bends.
2. Place 2 pads on each of the curved ends.
Base Assembly
(Model 743 only)
1. Align the pins (A) located on each base
B
2. Align and insert pivot knob (C) into hole
A
3. Place rubber washer (E) onto pivot knob.
F
D
C
E

Assembly

piece and insert into the holes (B) on each
base piece.
located on the base (D).
Then screw pivot knob into the head of unit
(F) until secure. Repeat on opposite side of
the base.
English 7