Great Dane C5 Chariot GCBR2661S Operator's Manual page 40

4.Loosen jam nut (A).
5.Check the mower deck drive belt (B) tension. The belt should deflect a
maximum of 13 mm (1/2 in.) when a force of 4.5 kg (10 lb) is applied to the
center of the longest span.
When properly adjusted, there would be approximately a 2 mm (1/16 in.)
gap between the spring coils.
• To increase belt tension: Turn nut (C) clockwise.
• To decrease belt tension: Turn nut (C) counterclockwise.
6.Tighten jam nut (A).
7.Lower foot platform.
Removing and Installing Mower Deck Drive Belt
1.Park machine safely. (See Parking Safely in the SAFETY section.)
2.Raise foot platform.
3.Remove mower deck drive belt covers.
4.Release mower deck drive belt tension by turning the tension adjuster
nut (A) counterclockwise.
SERVICE MOWER
CAUTION: Avoid injury! Fingers and hands can be pinched or
crushed. Keeps hands clear of sheave and belt pinch points
when servicing belt.
5.Remove mower deck drive belt (B).
A- PTO Clutch Sheave
B- Mower Deck Drive Belt
C- Tension Idler Sheave
D- Left Spindle Sheave
E- Center Spindle Sheave
F - Idler Sheave
G- Right Spindle Sheave
H- Idler Sheave
6.Install new mower deck drive belt (B) as shown.
7.Adjust belt tension.
8.Install mower deck drive belt covers.
9.Lower foot platform.
Checking and Replacing Mower Blades
CAUTION: Avoid injury! Do not work near raised mower deck
unless it is safely supported.
Service Mower - 38
•Mower blades are sharp. Wrap blades or wear gloves
when servicing.
•Before performing any service function, wait for all
moving parts to stop turning.
•Disconnect battery or remove spark plug wire before
making repairs.