Scientific Atlanta DPR2325 User Manual page 109

Field Name
Beacon Interval
DTIM Interval
Fragmentation
Threshold
RTS Threshold
Configuring Wireless Access Point Access Control
Use the Setup Wireless - Access Control page to configure your configure your
wireless access point access control.
Note: If you are not familiar with the advanced settings detailed in this section,
contact your service provider before you attempt to change any of the cable modem
gateway default wireless advanced settings.
Click Access Control in the Wireless section of the Setup page to access the Setup
Wireless - Access Control page.
4011533 Rev A
Description
Displays the time interval that the WAP uses to
announce itself to remote devices. The Beacon Interval
should be left at 100ms for compliance with most client
cards. The Beacon Interval specifies how often packets
are sent by the Access Point (AP) to synchronize a
wireless network and its clients
Displays the time interval between
Broadcasts/Multicast transmissions. The DTIM
(Delivery Traffic Indication Message) Interval is a
countdown informing the wireless clients of the next
window for listening to broadcast and multicast
messages. When the AP has buffered broadcast or
multicast messages for associated clients, it sends the
next DTIM with a DTIM Interval value. AP clients hear
the beacons and awaken to receive the broadcast and
multicast messages. The DTIM Interval should be left
at 3 ms for compliance with most client cards
Allows you to set the fragmentation threshold. This
threshold should be set equivalent to the maximum
Ethernet frame size allowable on the link including
overhead (1536 bytes). Lesser settings can damage data
throughput as large frames could be fragmented or
collisions could occur. The factory default is 2346
Determines at what packet size beyond which the
ready to send/clear to send (RTS/CTS) mechanism is
invoked. The factory default is 2347
How Do I Configure the Cable Modem Gateway?
109