Advertisement
(SCAN ）
In this mode, the screen will display DST、MXS、AVS、TM in sequence.
AUTO OFF – ENERGY SAVING
After 300 seconds no signal input, the computer/the screen will revert to its
'OFF' state with only the clock visible on the display. You may return the device
to normal operation by pressing any key.
CURRENT SPEED
This value will always be displayed on-screen. Speed values will range
from 0~99.9 KM/h(M/h).
" +" AND "—" COMPARATOR
"+" or "-" will display on the screen in the upper right corner. "+" will indicate when the current speed is higher than
average speed recorded, whereas "-" will indicate when the current speed is slower than average speed recorded
SAMPLING CYCLING MODE
While in any mode, sampling mode will be initiated when you press the left key. The screen will display the time of the
ride (TM). Press the right key to scan the value you have sampled: (DST) - (TM) - (AVS) - (MXS). Press the left key to
exist Sampling mode.
RESET ALL THE VALUES
Press the left and right key simultaneously for three seconds to clear and reset all the values.
USING THE TWO KEYS
Press the right key to select the following: ODO、DST、MXS、AVS、TM、SCAN、Clock.
All of the modes, with the exception of Sampling Mode, do not make use of the left key. When you enter into the
Sampling Mode, it can show several sampled values via use of the right key.
Press the left key again to exit Sampling Mode.
Advertisement
