Table of Contents
Advertisement
Laney
QUICK START SETTINGS - continued
EXTREME/METAL SETTINGS
I
V
NPUT
OLUME
General Notes
Amplifier connection: In order to avoid damage, it is advisable to establish and follow a pattern for turning on and off your
equipment. With all system parts connected, turn on source equipment, tape decks, cd players, mixers, effects processors etc.
BEFORE turning on your guitar amplifier. Many products have large transient surges at turn on and off which can cause damage to
your speakers. By turning on your guitar amplifier LAST and making sure its Volume control is set to minimum any transients from
other equipment will not reach your loudspeakers. Wait until all system parts have stabilised; usually a couple of seconds. Similarly
when turning off your system always turn down the Volume control on your guitar amplifier and then turn off its power before
turning off other equipment.
Cables: never use shielded or microphone cable for any speaker connections as this will not be substantial enough to handle the
amplifier load and could cause damage to your amplifier system.
Caution: These professional loudspeaker systems are capable of generating very high sound pressure levels. Use care with
placement and operation to avoid exposure to excessive levels that can cause permanent hearing damage. (Refer to guidelines on
page 2)
Servicing: The user should not attempt to service these products. Refer all servicing to qualified service personnel.
D
RIVE
IN
C
M
RUNCH
ASTER
E
QUALISATION
B
M
T
ASS
ID
REBLE
OPERATING INSTRUCTIONS
LX20D
E
CD/L
I
P
FFECT
INE
N
HONES
1
0
P
OWER
Page 10 /12
Advertisement
Table of Contents
