Folding The Handle; Removing The Mower From Storage - Toro Recycler 20332 Operator's Manual

Folding the Handle

Folding or unfolding the handle improperly can
damage the cables, causing an unsafe operating
condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an Authorized
Service Dealer.
1. Remove the ignition key (electric-start models only).
2. Loosen the handle knobs until you can move the
upper handle freely.
3. Fold the upper handle forward as shown in Figure 32.
Important: Route the cables to the outside of
the handle knobs as you fold the handle.
4. To unfold the handle, reverse the steps above.
Removing the Mower from
Storage
1. Remove the spark plug and spin the engine rapidly
by pulling the recoil start handle or using the electric
starter (electric-start models only) to blow the excess
oil from the cylinder.
2. Install the spark plug and tighten it with a torque
wrench to 15 ft-lb (20 N-m).
3. Charge the battery for 24 hours (electric-start models
only).
4. Connect the wire to the spark plug.
Figure 32
19