Harman Kardon DC520 Owner's Manual

Harman Kardon DC520 Owner's Manual

Dual cassette deck
Hide thumbs Also See for DC520:

Advertisement

Reset
Sync Rev
SECONDARY Transport
Inpu
PLAY
Auto Tape Selector
Dual Auto Reverse
Eject
Power
Direction Mode
Dolby NR
Off
B
C
Cont Play

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DC520 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Harman Kardon DC520

  • Page 1 Reset Sync Rev SECONDARY Transport Inpu PLAY Auto Tape Selector Dual Auto Reverse Eject Power Direction Mode Dolby NR Cont Play...
  • Page 2 Harman Kardon DC520 Dual Cassette Deck Reset Copy High Speed Copy Rec Mute PRIMARY Transport ut Level REC/PLAY Auto Tape Selector Dual Auto Reverse Record Eject Input Balance Headphones Owner’s Manual...
  • Page 3: Table Of Contents

    Owner’s Manual DC520 Dual Cassette Deck Table of Contents Introduction and Safety Information ....1–2 Front Panel Controls....... . . 3 Front Panel Display .
  • Page 4: Introduction And Safety Information

    To assure proper operation, and to avoid Verify Line Voltage Before Use The DC520 is an exceptionally well the potential for safety hazards, place Your DC520 has been designed for use with engineered product that offers high the unit on a firm and level 110-120 220~240 volt AC current.
  • Page 5: Introduction And Safety Information

    Please respect the environment and discard those materials at a local recycling center. When positioning your DC520 in its final location, make certain that any shelf or stand is capable of supporting its weight, and that there is adequate ventilation on all sides, as well as on the top and bottom.
  • Page 6: Front Panel Controls

    – Press this button to rewind the Kardon remote controls. Keep this area M Primary Transport Fast secondary tape. clear if you wish to use the DC520 with Forward – Press this button to rapidly Y Secondary Transport a remote control.
  • Page 7: Front Panel Display

    Single Deck Playback panel to the jacks of your TAPE INPUT 6. If you wish to clear the counter before The DC520 may be used as a conventional receiver or preamplifier. Connect the playback, press the button next to RESET...
  • Page 8: Operation

    When the button is With the switch in this mode, the DC520 3. Adjust the INPUT BALANCE released the unit will automatically go into...
  • Page 9: Tape Dubbing

    Tape Dubbing copy. In addition, the High Speed Mode is once, the DC520 will automatically repeat The DC520 is capable of both normal and susceptible to interference from the the process so that each side is played a total of five times without interruption. At...
  • Page 10 Primary (record) tape ends. At that (playback cassette) will continue to play. Reverse dubbing: time both transports will stop Listen to the output of the DC520 using simultaneously. either the tape monitor mode on your 1. Prepare the unit for dubbing as audio system or the front panel headphone described on page 6.
  • Page 11: Specifications

    When these tabs are manufacturer’s instructions to insure to avoid damage to your DC520. removed the tape may not be used for proper results. recording. To record on a tape that has 2.
  • Page 12: Troubleshooting Guide

    Troubleshooting The DC520 is designed for trouble-free operation. However, like any mechanical device it may occasionally malfunction. In most cases the trouble can be resolved simply by finding the problem from the list below and following the steps outlined. If a problem persists, contact your dealer or an authorized Harman Kardon Service Center.

Table of Contents